Welcome!

Welcome to Brady Diesel Services, Diesel Knowledge Forum. Ask questions and we can post answers. You must be a registered user to ask questions.

0

VT 365 (6.0) Crank No Start Checklist

By
Allen Brady
on 2/8/20, 1:29 PM 139 views

[ First of all buy a scanner able to scan parameters on these trucks ]

1. Check oil at the dipstick make sure its above add mark.

2. Have someone crank engine and push down plunger at oil filter housing. If oil comes up your Low Oil Pressure Pump is getting oil thru the system.

3.If no oil is getting in the oil filter housing check the oil regulator located near the LPOP now by the crankshaft damper in front of the engine, you need a Allen Key to remove, check for grimy and or stick oil left on the spring, clean it off and inside regulator and install.

4. If sill no crank no start, look at values on a scanner, Sync, Ficm Sync, ICP Pressure above 500, IPR Duty Cycle,.

5. Call us we can connect to these trucks and have endless experience with these vehicles including wire troubleshooting..


Your Answer

Please try to give a substantial answer. If you wanted to comment on the question or answer, just use the commenting tool. Please remember that you can always revise your answers - no need to answer the same question twice. Also, please don't forget to vote - it really helps to select the best questions and answers!

Keep Informed

About This Community

This community is for professionals and enthusiasts of diesel engines and transmissions. We will update new information regularly such as schematics, and information. Read Guidelines

Question tools

1 follower(s)

Stats

Asked: 2/8/20, 1:29 PM
Seen: 139 times
Last updated: 2/8/20, 1:29 PM